The Work Flow And Movement Mode Of Gate Valve

    Gate Valve headstock is the gate, the movement direction of the gate and the direction of the fluid, the gate valve can only be open and full off, can not be adjusted and throttling. The gate has two sealing surfaces, the most commonly used mode gate valve two seals form the wedge shape, the wedge angle with the valve parameter and the different, usually is 5 °, the medium temperature is not high when 2 52 '. The wedge-type gate valve can be made into a whole, called a rigid gate plate, can also be made to produce micro-deformation of the brake board to improve its process, to make up for the sealing surface angle in the process of the deviation generated, this kind of gate is called the elastic Gate.Gate Valve
    Most of the gate valves are forced seal, that is, when the valve is closed, it is necessary to force the gate to be pressed to the valve seat to ensure sealing surface. Gate valve board with the valve stem for a straight line movement, called the lifting rod gate valve, also known as the Ming rod gate valve. Usually, there is a trapezoidal thread on the lifter, through the nut on the top of the valve and the guide groove on the valve body, turning the rotation movement into a straight line motion, that is, turning the operation torque into operational thrust. When opening the valve, when the gate lifting height is equal to the valve diameter of 1:1 time times, the flow of the channel is fully unblocked, but at run time, this location is not monitored. In actual use, it is the vertex of the stem as a sign, that is, the position of the open, as its full opening position.Gate Valve
Movement mode: Gate valve of the gate with the valve stem for a straight line movement, also known as the Ming rod gate valve. Usually, there is a trapezoidal thread on     the lifter, through the nut on the top of the valve and the guide groove on the valve body, turning the rotation movement into a straight line motion, that is, turning the operation torque into operational thrust. When opening the valve, when the gate lifting height is equal to the valve diameter of 1:1 time times, the flow of the channel is fully unblocked, but at run time, this location is not monitored. In order to consider the phenomenon of temperature change deadlock, usually in the vertex position, and then pour back to the 1 2 1 circle, as the position of open valve. Therefore, the open position of the valve, according to the position of the gate (that is, stroke) to determine. Some gate valve stem nut is located on the brake board, the handwheel rotates to drive the stem to rotate, and make the gate ascend, this kind of valve is called the revolving rod gate valve or called the Dark Pole gate valve.Gate Valve